Filter
Top Products
The HBAnyware Utility User Manual Page 98
2. Select the Target Mapping tab. All targets are displayed.
Figure 38: Target Mapping tab
3. Target mappings are displayed by WWPN, WWNN, or D_ID. “PB”, indicates mapping from
persistent binding, while “Auto”, indicates an automapped target. In the Display Mode section,
choose the display mode you want to use.
4. Change Setting - Click to change the active bind type (the mode used to persistently bind target
mappings), LUN automapping or LUN unmasking settings. Select the active bind type (WWPN,
WWNN or D_ID), enable or disable LUN automapping and/or set enable or disable LUN
unmasking.
To add a persistent binding:
1. In the Targets Table, click the target that you want to bind.
2. Click Add Binding. The Add Persistent Binding dialog box is displayed.
Figure 39: Add Persistent Binding dialog box
3. Select the bind type that you want to use (WWPN, WWNN or D_ID).