Filter
Top Products
The HBAnyware Utility User Manual Page 131
Parameters:
WWPN - World Wide Port Name of the HBA whose driver parameters you wish to change.
Flag1 - L = Make change local for this HBA only, G = Make change global (all HBAs on this host)
Flag2 - P = Make change permanent (persists across reboot), T = Make change temporary
Param - Name of the parameter to modify.
Value - New value you want to assign to the parameter (Input as decimal, prefix with 0x to input as hex).
SetDriverParamDefaults
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd SetDriverParamDefaults <WWPN> <Flag1> <Flag2>
Description: Changes all values to the default for the HBA(s).
Parameters:
WWPN - World Wide Port Name of the HBA whose values you want to change to the default.
Flag1 - L = Make changes local for this HBA only, G = Make changes global (all HBAs on this host)
Flag2 - P = Make changes permanent (persists across reboot), T = Make changes temporary
SetBootBios
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS), Linux and VMware ESX Server.
Syntax: hbacmd SetBootBios <WWPN> <Flag>
Description: Enables or disables the boot code on the HBA.
Parameters:
WWPN - World Wide Port Name of the HBA whose boot code you wish to enable or disable.
Flag - E = Enable the boot code, D = Disable the boot code
GetAuthConfig
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd GetAuthConfig <WWPN1> <WWPN2>
Description: Retrieves the authentication configuration for the HBA.
Parameters:
WWPN1 - World Wide Port Name of the HBA whose configuration data you wish to retrieve.
WWPN2 - Must be ff:ff:ff:ff:ff:ff:ff:ff
Note: For VMware ESX Server, CtrlWord - P = Make change permanent, G = Make change
global, B = Both, N = Neither. Because P and B are not supported on VMware ESX
Server you can only use G or N.
Note: VMware ESX Server uses the syntax <Ctrlword> rather than <Flag>.