Filter
Top Products
The HBAnyware Utility User Manual Page 39
Target Mapping Field Definitions
Current Settings Area
• Active Bind Type - WWPN, WWNN, or a destination identifier (D_ID).
• Automapping - The current state of SCSI device automapping: enabled (default) or disabled.
Current Mappings Area
• This table lists current mapping information for the selected HBA.
Persistent Binding Configuration Area
• This table lists persistent binding information for the selected HBA.
Display Mode Radio Buttons
• Show WWPN, Show WWNN or Show D_ID.
Target Mapping Buttons
• Refresh - Click to refresh the Target Mapping tab.
• Change Settings - Click to change the active bind type (the mode used to persistently bind target
mappings), LUN automapping or LUN unmasking settings. The Mapped Target Setting window
is displayed. Select the active bind type (WWPN, WWNN, D_ID or AL_PA), set LUN
automapping to enabled or disabled, and/or set LUN unmasking to enabled or disabled.
• Add Binding - Click to add a persistent binding.
• Bind New - Click to add a target that does not appear in the Persistent Binding table.
• Remove - Click to remove the selected binding.
• Remove All - Click to remove all persistent bindings that are displayed.
Viewing Target Mapping (Linux)
Use this tab to view target mapping. The Target Mapping tab is read-only.
To view target mapping:
1. Select Host or Fabric sort.
2. Select the HBA in the discovery-tree whose target mapping information you wish to view.
Note: Persistent binding is not supported by the Linux 2.6 kernel or by the Emulex version 8.0 driver for Linux.