Filter
Top Products
The HBAnyware Utility User Manual Page 51
Figure 34: Driver Parameters tab - Host Selected
5. Enter a new value in the Value field in decimal or hexadecimal format, depending on how the
current value is presented. If the value is in hexadecimal format, it is prefaced by "0x" (for
example” 0x2d”).
6. To make a change temporary (the parameter to revert to its last permanent setting when the
system is rebooted), check the Make changes temporary box. This option is available only for
dynamic parameters.
7. To make changes to multiple parameters, check the Make all changes temporary box. Only
dynamic parameters can be made temporary.
8. Click Apply.
Changing Non-dynamic Parameter Values (Linux)
To change non-dynamic parameter values:
1. Navigate to the /usr/sbin/hbanyware directory and run the scripts to stop the HBAnyware utility
processes. Type:
./stop_hbanyware
2. Stop all I/O to LPFC attached devices.
3. Unload the lpfcdfc driver. Type:
rmmod lpfcdfc
4. Unload the LPFC driver. Type:
rmmod lpfc
5. Reload the driver.Type:
modprobe lpfc
modprobe lpfcdfc
The HBAnyware services will start automatically when you launch the application.
For these changes to persist after a reboot you must create a new ramdisk image.