Filter
Top Products
The HBAnyware Utility User Manual Page 134
SetBeacon
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd SetBeacon <WWPN> <BeaconState>
Description: Sets the current beacon status for the HBA.
Parameters:
WWPN - World Wide Port Name of the HBA whose beacon you wish to change.
BeaconState - New state of the beacon: 0 = Off, 1= On
PostTest
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd PostTest <WWPN>
Description: Runs the POST on the HBA. Support for a remote HBA is TCP/IP access only.
Parameters:
WWPN - World Wide Port Name of the HBA on which you wish to run a POST.
EchoTest
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd EchoTest <WWPN Source> <WWPN Destination> <Count> <StopOnError> <Pattern>
Description: Runs the echo test on HBAs.
Parameters:
Source WWPN - World Wide Port Name of the originating HBA.
Destination WWPN - World Wide Port Name of the destination (echoing) HBA.
Count - Number of times to run the test. 0 = run test infinitely
StopOnError - Should the test be halted on Error? 0 = No halt, 1 = Halt
Pattern - Hexadecimal data pattern to transmit (up to 8 characters).
Loopback
Supported by: Windows, Solaris LPFC, Solaris emlxs (SFS) and Linux.
Syntax: hbacmd loopback <WWPN> <Type> <Count> <StopOnError> <Pattern>
Description: Runs the loop test on the HBA specified by the WWPN.
Parameters:
WWPN - World Wide Port Name of the HBA on which you wish to run loopback.
Type - 0 = PCI LoopBack Test, 1 = Internal LoopBack Test, 2 = External LoopBack Test
Count - Number of times to run the test (0 = run test infinitely, Range = 1...99,999)
StopOnError - Should the test be halted on Error? 0 = No halt, 1 = Halt
Pattern - Hexadecimal data pattern to transmit (up to 8 characters).
Note: Support for remote HBA is TCP/IP access only. The EchoTest command will fail if the
target WWPN does not support the ECHO ELS command.
Note: Only external loopback tests must be run with TCP/IP access.