Filter
Top Products
The HBAnyware Utility User Manual Page 90
lpfc_discovery_threads 32 1 64 Specifies the maximum
number of ELS commands
that can be outstanding for
a discovery.
NOTE: The
discovery_threads
parameter will default to a
value of 64 for private loop
topologies regardless of the
configured value. If there
are multiple ports
configured on the host the
value of 64 will only be
used for those ports that
are connected in a private
loop topology. The
configured value will be
used for all other ports.
No
lpfc_enable_npiv 0 0 1 This parameter controls the
driver’s ability to use NPIV
to create virtual ports. It
defaults to off (0) which
prevents the driver from
creating any virtual ports.
When enabled (set to 1) it
enables you to create and
delete virtual ports (if
supported by the fabric).
Yes
lpfc_fcp_class 3 2 3 The Fibre Channel class for
FCP data transmission.
Yes
lpfc_hba_queue_depth 8192 32 8192 The maximum number of
FCP commands that can
queue to an Emulex HBA.
Yes
lpfc_lun_queue_depth 30 1 128 The default maximum
commands sent to a single
logical unit (disk).
Yes
lpfc_fdmi_on 0 0 2 False (0) if disabled. (1) or
(2) if enabled depending on
type of support needed.
Yes
lpfc_scan_down 1 0=Off 1=On Selects method for
scanning ALPA to assign a
SCSI ID.
Yes
Table 9: lpfc Static Parameters (Requires a driver reload to change) (Continued)
Variable Default Min Max Comments
Visible
using
sysfs