Filter
Top Products
The HBAnyware Utility User Manual Page 73
topology Controller
Specific
0x0 0x0=loop , then
P2P
0x2=P2P only
0x4=loop only
0x6=P2P, then
loop
No This variable controls the FC
topology expected by LPFC at
boot time. FC offers point-to-
point, fabric, and arbitrated
loop topologies.To make the
HBA operate as an N_Port,
select point-to-point mode
(used for N_Port to F_Port,
and N_Port to N_Port
connections). To make the
HBA operate in a FC loop as
an NL_Port, select loop mode
(used for private loop and
public loop topologies). The
driver will reject an attempt to
set the topology to a value not
in the above list. The auto-
topology settings 0 and 6 will
not work unless the HBA is
using firmware version 3.20 or
higher.
use-adisc Controller
Specific
0 0=Off 1=On Yes This variable controls the ELS
command used for address
authentication during re-
discovery upon link-up. If set,
ADISC is used, otherwise,
PLOGI is used. For FCP-2
devices, the driver will always
use ADISC. For re-discovery
due to a RSCN, the driver will
always use ADISC.
xmt-que-size Controller
Specific
256 128 10,240 No This variable specifies the
number of network packets
that can be queued or
outstanding at any time in the
driver. Increase this setting for
better IP performance under
heavy loading.
Table 3: LPFC.conf Parameters (Continued)
Property Name Scope Default Min Max Dynamic Comments