Filter
Top Products
Operation Using
a Programmable Logic Controller (PLC)
Read Fluid Control Mode
The Read Fluid Control Mode command is used to
read the current Fluid Control mode of the system
is currently operating under. No arguments are
required.
Example: Read Fluid Control as currently set to
Pressure mode.
DCS Register
Parameter Description Data
Type
Units Value Range
DCS
Command
Read Fluid Control Mode
uint32
NONE
13 0 - 16
Acknowledge
Command Ac
knowledged
uint32
NONE 2 = ACK
0-4
0=FlowReturn 0
Fluid Control Mode
uint32
NONE
1 = Pressure
1=Pressure
332564B 53