Graco 332564B Paint Sprayer User Manual


 
System Errors
Error Codes
NOTE: When an error occurs be sure to determine the code before resetting it. If you forget which code
occurred, use the Errors Screen, page 65 to view the last 200 errors, with date, time, and description.
Purge Errors
Code
Type Description Problem
Cause Solution
Air flow switch is stuck
in flow position.
Clean or replace switch.
Leak downstream in air
line or fitting.
Check for leaks and
tighten fittings.
F7P1 Alarm Air Flow
Switch On
The air flow switch is
indicating unexpected
atomizing air flow.
Air supply pressure
fluctuation.
Eliminate pressure
fluctuations.
Solvent flow switch not
working.
Replace switch.
Solvent flow is too low
to actuate the solvent
switch.
Increase solvent
pressure to drive a
high purge flow rate
Gun is not triggered. Operator must continue
flushing for configured
time, until the booth
control indicates purge
is completed.
SPD1
Alarm
Gun Purge
Incomplete
Thesystemtimedout
without reaching the
user-specified volume
of solvent for a purge.
Mix manifold was not
set to flush position,
blocking solvent flow to
the spray gun.
Setmanifoldtoflush
position.
Mix Errors
Code
Type Description Problem
Cause Solution
Solvent flow switch is
stuck in flow position.
Clean or replace switch.F7S1
Alarm Flow
Detected
Solvent
Gun
The solvent flow
switch is indicating
unexpected solvent
flow.
There is a leak through
the solvent cutoff valve.
Check for leaks and
repair valve.
Purge process was not
completed.
Make sure purge
process is completed.
QPD1
Alarm,
then
Devia-
tion
Potlife
Expired
Potlife time has expired
before the system has
moved the required
amount of material
(potlife volume) through
the mixed material line.
Solvent supply shut off
or empty.
Verify solvent supply
is available and on,
supply valves are open.
Mix manifold not set to
spray position.
Set manifold to spray.
Spraygunwasnot
triggered.
Allow flow through gun
during fill process until
the fill complete LED
stops flashing.
SND1
Alarm Mix Fill
Incomplete
The system timed out
before the mix fill cycle
loaded the gun with
mixed material.
Restrictions in mixer,
manifold, or spray gun.
Fix restrictions.
332564B 89