Filter
Top Products
Run M ode Screens
Fill Screen
NOTE: This screen is visible only if manual override
is enabled on System Screen 5, page 71.
The Fill scre
en displays the following information for
the pump assi
gned to the current color:
• Material. Select Color (A), Catalyst (B), or Solvent.
The pump animation at the top of the screen will
show the selected material.
• Flush Line (only for systems with color change).
Select this box if you want to flush the specified
material line. The system uses flush sequence 1.
To prime the pumps and fill the lines, first read
Prime and Fill the System, page 20.
1. Press the Edit softkey
to open the screen
for editing.
2. Select Color (A).
3. If the selected material is not already loaded,
press th
e Prime softkey
. The system will
prime C
olor (A) into the selected pump through
the sel
ected color valve and out the outlet dump
valve.
4. Press the Fill softkey
. The system will
attempt to fill the Color (A) lines until the user
pres
ses Stop
. Trigger the gun into a waste
cont
ainer.
5. Repe
at for Catalyst (B).
Figure 19 Fill Screen, Color (A) Selected
Figur
e 20 Fill Screen, Solvent Selected
332564B 63