Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
RETEST AFTER REPAIR
Retest a machine:
• If it is rejected under test for any reason that requires you to remove any mechanical part
which could affect the machine’s electrical characteristics.
OR
• If you repair or replace any electrical components.
NOTE: 50 Hz machines may be tested using 60 Hz power.
INPUT AMPS AT RATED MACHINE OUTPUT
Input Volts/Hertz Load Amps
208/60 110
230/60 100
460/60 50
575/60 40
200/50 115
220/50 104
380/50 61
440/50 52
INPUT IDLE AMPS
Input Volts/Hertz Maximum Idle Amps
230/60 62
220/50 50
NOTE: Power factor correction capacitors are standard on all models. The capacitors
cause high idle currents, but idle power is low.
OPEN CIRCUIT VOLTAGES
Stick Mode OCV AC 60-70
DC 60-70
TIG Mode OCV AC 60-70
DC 60-70
TROUBLESHOOTING & REPAIR
F-84 F-84
SQUARE WAVE TIG 355