Filter
Top Products
CONTROLS AND SETTINGS
UPPER CASE FRONT CONTROLS
Controls on the upper case front control panel are
used for manual TIG and stick welding. Their func-
tions are described below. Some controls are active in
both TIG and stick welding, while others are active in
TIG only. Refer to Figure B.1 for control locations.
OPERATION
B-5 B-5
SQUARE WAVE TIG 355
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
1. REMOTE/LOCAL CURRENT CONTROL SWITCH 7. VOLTS/AMPS METER SWITCH 12. PREFLOW TIMER
2. MODE SWITCH (STICK/TIG) 8. AC WAVE BALANCE 13. SPOT CONTROLS
3. 2-STEP/4-STEP SWITCH 9. AUTO-BALANCE™ LED 14. START CONTROLS
4. HIGH FREQUENCY SWITCH 10. AFTERFLOW 15. PULSE CONTROLS
5. DIGITAL VOLTMETER/AMMETER 11. STICK ARC FORCE 16. CRATER FILL CONTROLS
6. PEAK CURRENT CONTROL 17. STATUS INDICATOR LEDs
FIGURE B.1 – UPPER CASE FRONT CONTROLS
5
3
2
1
4
6 7
8
9
10
11
17
16
15
14
13
12