Filter
Top Products
CONTROL OR POWER BOARD
REMOVAL AND REPLACEMENT PROCEDURE (continued)
INSTALLATION PROCEDURE
1. Install either the power or control board to the
PC board assembly and secure it in place.
2. Carefully slide the power and control PC
board assembly into place, making sure to
clear the lead harnesses on the right and left
side of the PC board compartment.
3. Secure the rear of the control box in place.
4. Connect two molex plugs and black and white
wires with quick disconnects to the power PC
board.
5. Connect the molex plugs to the control PC
board.
6. Install the PC board compartment cover using
the 3/8 in. nutdriver.
7. Install the case top and sides using the 3/8 in.
nut driver and Phillips screwdriver.
TROUBLESHOOTING AND REPAIR
F-61 F-61
INVERTEC® V450-PRO
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC