Filter
Top Products
CHOKE/IRON
CHOKE/IRON
FIGURE F.14 – CHOKE ASSEMBLY
CHOKE TEST PROCEDURE (continued)
PROCEDURE
1. Using an Ohmmeter, make sure that the
choke windings are not grounded to the
lamination (> 1megohm).
TROUBLESHOOTING AND REPAIR
F-54 F-54
INVERTEC® V450-PRO
No windings or terminal connections should look
burned or over-heated. AC welding may cause
choke to buzz slightly.
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC