Filter
Top Products
FAN CONTROL AND MOTOR TEST (continued)
TROUBLESHOOTING AND REPAIR
F-50 F-50
INVERTEC® V450-PRO
TEST PROCEDURE
1. Remove the input power to the V450-PRO
machine.
2. Using the 3/8” nut driver, remove the case top
and control box cover.
3. Perform the Capacitor Discharge Procedure.
4. Carefully apply the correct input power to the
machine.
5. Carefully check for 115VAC at X3A and 444.
See Figure F.12.
WARNING
: HIGH VOLTAGE IS PRESENT AT
THE RELAY TERMINALS.
6. If the 115VAC is low or not present, perform the
Auxiliary Transformer Test. Check circuit
breaker CB2 and associated leads for loose or
faulty connections. See Wiring Diagram.
7. Energize the weld output terminals (Select
Weld Terminals ON) and carefully check for
115VAC at the fan motor leads. If the 115VAC
is present and the fan is not running, the fan
motor may be faulty. See Wiring Diagram.
WARNING
: HIGH VOLTAGE IS PRESENT AT
THE FAN LEADS.
ELECTRIC SHOCK can kill.
High voltage is present when input
power is applied to the machine.
FAN CONTROL TEST PROCEDURE
1. Locate plug J7 on the control board. Do not
remove the plug from the control board. See
Figure F.12.
2. Energize the weld output terminals (Select
Weld Terminals ON) and carefully check for
+15VDC at plug J7 pins 15 & 16 on the control
PC board. If the 15VDC is present and the fan
is not running then the relay or fan may be
faulty. If the 15VDC is not present when the
weld terminals are energized, then the control
board may be faulty.
HIGH VOLTAGE IS PRESENT
AT THE SWITCH BOARD.
Fan comes on when
output is enable
3R
FAN CONTROL (+15VDC)
FAN CONTROL (-)
J7-15
J7-16
3W
CR2
+
-
X
3A
4
44
T
P4
F
AN
SOLID STATE
RELAY
Located in Rear of
PowerSource
Fan comes on when
output is enable
3R
FAN CONTROL (+15VDC)
FAN CONTROL (-)
J7-15
J7-16
3W
CR2
+
-
X
3A
4
44
T
P4
F
AN
SOLID STATE
RELAY
Located in Rear of
PowerSource
FIGURE F.12
WARNING
WARNING
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC