Filter
Top Products
Manage the Internet Settings Manually
55
AC1600 WiFi VDSL/ADSL Modem Router Model D6400
13. Enter the ADSL settings as described in the following table.
Field Description
Multiplexing Method Select LLC-BASED or VC-BASED, as indicated by your ISP.
The multiplexing method can either be virtual circuit (VC) based or logical
link control (LLC) based.
VPI Enter a number between 0 and 255 for the virtual circuit number for the
virtual path identifier (VPI), as indicated by your ISP
.
If your ISP did not provide you with a VPI setting, leave the default setting
(0).
The VPI might be required not only for a VC-based connection but also
for an LLC-based connection.
VCI Enter a number between 32 and 65535 for the virtual circuit number for the
virtual channel identifier (VCI), as indicated by your ISP
.
If your ISP did not provide you with a VCI setting, leave the default setting
(35).
The VCI might be required not only for a VC-based connection but
also for an LLC-based connection.
Use VLANID Select the
Use VLANID check box and enter the VLAN ID, as indicated by
your ISP
.
A VLAN ID might be required if you subscribe to both Internet service and
IPTV service. If your ISP did not provide you with a VLAN ID, leave the
Use
VLANID check box cleared, which is the default setting.
For information about setting up VLAN tag groups, see Set Up a Bridge for
a VLAN Tag Group on page 198.
Priority (802.1p) If your ISP provided you with a VLAN ID and a priority value, enter the
priority value, which is a number from 0 to7.
You can enter a priority value only in combination with a VLAN ID. If your
ISP did not provide you with a priority value, leave the default setting (0).
Bridge Mode (bind LAN4 to
W
AN2)
This setting is an option that applies to the IPTV interface only
. To bind LAN
port 4 to the IPTV interface (that is, the WAN2 virtual interface), select the
Bridge Mode (bind LAN4 to WAN2) check box.
For more information, see Enable Bridge Mode for an IPTV Device on
page 200.
Encapsulation Select the encapsulation, as indicated by your ISP:
• PPPoE.
Y
our Internet connection uses PPP over Ethernet.
• PPPoA. Y
our Internet connection uses PPP over ATM.
Login Enter the login name that you use to log in to your Internet service, as
indicated by your ISP.
This login name is often an email address.
Password Enter the password that you use to log in to your Internet service, as
indicated by your ISP
.
Service Name (If Required) Enter the service name that you use to log in to your Internet service, as
indicated by your ISP.
Often, a service name is not required.
Note: This field does not display if your selection from the Encapsulation
menu is
PPPoA.