Filter
Top Products
Simple Network Management Protocol
SNMP Trap Configuration
SN0051103-00 A B-3
A
SNMP Trap Configuration
SNMP trap configuration lets you set up to eight trap destinations. Choose from
Traps 1–Trap 8 to configure each trap. Table B- 2 describes the parameters for
configuring an SNMP trap.
Table B-2. SNMP Trap Configuration Parameters
Parameter Description
Trap n enabled Enables or disables trap n. If disabled, the trap is not configured.
Trap address
*
Specifies the IP address to which the SNMP traps are sent. A maximum of eight
trap addresses are supported. The default address for traps is 0.0.0.0.
Trap port
*
Port number on which the trap is sent. The default is 162. If the trap destination is
not enabled, then this value is 0 (zero). Most SNMP managers and management
software listen on this port for SNMP traps.
Trap version Specifies the SNMP version (1 or 2) with which to format traps.
Table Note
* Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2
have the same address, then they must have different port values. Similarly, if trap 1 and trap 2 have the same port
value, they must have different addresses.