Filter
Top Products
Introduction
iSR6250 Router Blades
SN0051103-00 A 1-9
A
Enabling DHCP by this method is not persistent; to make the change persistent,
use the command line interface (CLI) or SANsurfer Router Manager to enable
DHCP. For details, see the iSR6200 Router Manager User's Guide and the
iSR6200 Router CLI User's Guide.
Restore Factory Defaults
To reset the router and restore it to the factory default configuration, use a pointed,
nonmetallic tool to press the maintenance button and hold it until the heartbeat
LED flashes 20 times, then release the button. The router boots and is restored to
the factory defaults. The boot time is less than one minute.
The router does the following when restored to the factory defaults:
Clears all router log entries.
Resets all passwords.
Resets the maintenance port IP address to 10.0.0.1.
Disables the iSCSI ports and sets the IP address to 0.0.0.0.
Erases all presentations.
Erases all discovered initiators and targets.
Fibre Channel Port LEDs
The iSR6250 router has two Fibre Channel ports. The ports are labeled FC1 and
FC2, as shown in Figure 1-8.
Figure 1-8 Fibre Channel LEDs
The port LEDs are located to the right of their respective ports and provide status
and activity information.
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
8Gb (Yellow)
4Gb (Green)
2Gb (Amber)