Filter
Top Products
Introduction
iSR6250 Router Blades
SN0051103-00 A 1-7
A
Input Power LED (Green)
The power LED shows the voltage status of the router logic circuit board. During
normal operation, this LED lights up to show that the router logic circuit board is
receiving the DC voltage from the power supply.
Beacon Indicator (Blue)
The iSR6250 router blade’s PCB has a blue beacon light installed near the center
vent hole between the FC ports (Figure 1-6). This light enables you to locate the
physical blade when monitoring the iSR6250 routers using the SANsurfer Router
Manager. If you enable the Beacon On option for a selected blade in the Router
Manager, the blue beacon light flashes through the vent hole on the chassis
blade’s face plate.
Maintenance Button
The maintenance button shown in Figure 1-7 is the only router blade control.
Press this button to reset the router blade or to recover it if it becomes disabled.
Figure 1-7 Maintenance Button
The maintenance button is a multifunction momentary switch on the front panel. It
has the following functions:
Reset a Router Blade (see page 1-8)
Reset and Select Boot Image (see page 1-8)
Reset IP Address (see section page 1-8)
Enable DHCP (see section page 1-8)
Restore Factory Defaults (see page 1-9)
MGMT IOIOI
FC1 FC2 GE1 GE1
GE4 GE3 iSR6240
Intelligent Storage Router
iSR6200 System
10GbE1 iSR6250
Intelligent Storage Router
10GbE2
Maintenance Button