Filter
Top Products
Command Descriptions
TDS Family Oscilloscope Programmer Manual
2–181
LIMit:BELl
Rings the bell when the waveform data exceeds the limits set in the limit test, if
the limit state is on.
Limit Test
LIMit:COMPARE:CH<x>, LIMit:STATE
LIMit:BELl { OFF | ON | <NR1> }
LIMit:BELl?
BELl
:
LIMit
ON
<Space>
?
<NR1>
OFF
OFF or <NR1> = 0 turns off ringing the bell when any waveform data exceeds the
limits set by the limit test.
ON or <NR1> 0 turns on ringing the bell.
LIMit:BELl ON
specifies that the bell is to ring when any waveform data exceeds the limits
specified in the limit test.
LIMit:BELl?
returns either 0 or 1, indicating whether the bell is to ring when any waveform
data exceeds the limits specified in the limit test.
LIMit:COMPARE:CH<x>
Sets or queries the template against which to compare the waveform acquired
through the specified channel. The template can be a waveform saved in any of
the reference locations REF1 through REF4, or none.
Limit Test
Group
Related Commands
Syntax
Arguments
Examples
Group