Filter
Top Products
Command Descriptions
2–54
TDS Family Oscilloscope Programmer Manual
ACQUIRE:REPET?
might return 1, indicating that repetitive signal acquisition mode is on.
ACQuire:STATE
Starts or stops acquisitions. This is the equivalent of pressing the front-panel
RUN/STOP button. If ACQuire:STOPAfter is set to SEQuence, other signal
events may also stop acquisition.
Acquisition
ACQuire:NUMACq?, ACQuire:REPEt, ACQuire:STOPAfter
ACQuire:STATE { OFF | ON | RUN | STOP | <NR1> }
ACQuire:STATE?
ACQuire
:
STATE
OFF
<Space>
?
ON
STOP
RUN
<NR1>
OFF or STOP or <NR1> = 0 stops acquisitions.
ON or RUN or <NR1> 0 starts acquisition and display of waveforms. If the
command was issued in the middle of an acquisition sequence (for instance
averaging or enveloping), RUN restarts the sequence, discarding any data
accumulated prior to the STOP. It also resets the number of acquisitions.
ACQUIRE:STATE RUN
starts acquisition of waveform data and resets the number of acquisitions count
(NUMACQ) to zero.
ACQUIRE:STATE?
returns either 0 or 1, depending on whether the acquisition system is running.
Group
Related Commands
Syntax
Arguments
Examples