Filter
Top Products
Sensor I® Expert User Manual
To Tighten to a Torque
Set the torque value to your target torque, and set high and low torque and
angle limits if desired. Snug is set automatically to a default value. This is
the point from which the angle is activated. The default snug values for all
models are listed in the TOLL DESCRIPTION Technical data table in Chapter
2. Reset the wrench before tightening. The OK light will go on and an alarm
will sound when the target is reached. If the wrench is pulled too slowly for
a long period (<10° per second for model 40, <5° per second for more than
5 seconds for all other models), the wrench will signal an error by sounding
several short beeps.
To Tighten to an Angle
Set the snug torque and target angle as well as any high and low torque and
angle limits. Reset the wrench before tightening. The Ok light will go on and
an alarm will sound when the target is reached. If the wrench is pulled too
slowly for a long period (<10° per second for 5 seconds for model 40, <5°
per second for more than 5 seconds for all other models), the wrench will
signal an error by sounding several short beeps.
To Tighten to Yield
Snug torque should be set to approximately 50% of the expected proof load
torque of the bolt in use. Set any required torque or angle limits, and select
your joint type-hard, normal or soft. Reset the wrench before tightening.
The OK light will go on and an alarm will sound when the target is reached.
If the wrench is pulled too slowly for a long period (<10° per second for 5