Filter
Top Products
42
Sensor I® Expert User Manual
8. Release the Reset button and rotate the Mode switch to the tightening
mode position for which the multiplier was enabled. The multiplier is
now enabled for that primary tightening mode.
NOTE
It is only possible to have one programmable multiplier value in
operation at any time.
NOTE
Entering the multiplier set mode for a particular tightening mode
resets the cycle count and flushes the data buffer for that mode.
Use of a Torque Multiplier
The torque multiplier can be used when the capacity of the Expert wrench is
below that required for the tightening application.
Once setup as described in Setup of a Torque Multiplier, the wrench is then
used in any of the primary modes as previously described. The joint
selection setting should be set at “soft” joints for Yield Control Tightening.
This is done by using the Joint key.
NOTE
Users should be aware of any torque reaction requirements or capacity
restrictions on the torque multiplier being used.
LEFT HAND FASTENERS
Custom Setup Mode #103 allow the user to select tightening direction (CW
or CCW).
1. The wrench display shows "---".