Filter
Top Products
27
Sensor I® Expert User Manual
Deleting Quality Control Limits
1. Press and release the Reset button to power the wrench.
2. Move the Mode Selection switch to the tightening mode required.
3. Press the Window key. You will see "--.-" on the display along with "LT"
flashing in the top left hand corner.
4. Press and hold in the Reset button. The present low torque limit will be
shown.
5. While holding in the Reset button, use the Parameter Adjustment Knob
to adjust the low torque limit to the torque value (target torque value
for Torque Control). Release the Reset and press the Window key.
6. To delete the torque high limit (HT), press the Window key until "HT" is
flashing. Then hold in the Reset button and adjust this to the snug
torque value (target torque value for torque control). Release the Reset
button and press the Window key.
7. To delete the angle low limit (LA), press the Window key until "LA" is
flashing. Then hold in the Reset button and adjust this value to zero.
Release the Reset button and press the Window key.
8. To delete the angle high limit (HA), press the Window key until the "HA"
is flashing. Then hold in the Reset button and adjust this value to zero.
Release the Reset button and press the Window key.
9. When all adjustments have been made, press the Window key until all
indicators (LT, HT, LA, HA) have stopped flashing on the display.
10. Press and hold the Reset button until the RUN light appears and com-
mence tightening.