Filter
Top Products
51
Sensor I® Expert User Manual
BATTERY CHARGING
The battery must be recharged as soon as "LO BAT" appears on the display.
The charger connects to the charger/data port (item 8 in Chapter 2: Tool
Description).
1. Remove the protective cap from the wrench handle (models 125, 250
and 400 only).
2. Insert the battery charger connector into charger/data port and plug the
charger into the main AC electric supply. (All models).
3. After the battery is charged, remove the charger connector. (All models.)
4. Reinstall the protective end cap (models 125, 250 and 400 only).
NOTE
• It takes approximately 14 hours to completely charge a fully discharged battery,
resulting in approximately 5.5 hours of continuous use. Shorter charging times may
result in reduced hours of continuous use.
• The battery should be charged as soon as possible after "LO BAT" appears on the
display. The wrench can be operated in the "LO BAT" condition. When it reaches a
level where it cannot operate with accuracy, "---" will show on the display and the
wrench will not operate.
• It is recommended that batteries be fully charged for each work shift.