Filter
Top Products
35
Sensor I® Expert User Manual
6. While holding the Reset button, press the Units key to select the option.
The display will show "ON". To deselect this option press the Joint key
deselects it.
7. Rotate the Mode Select switch back to the Setup position. The display
should now show "---" with TX on.
8. Holding in the Reset button, adjust the Custom Setup Mode number
below 20.
9. Release the Reset button and move the Mode Selection switch to the
desired tightening mode.
Data Out at End of Tightening
Once this function is activated, the final tightening data will be transmitted
to the PC via the serial port when Reset button is pressed at the completion
of tightening.
1. Connect the serial cable from the charger/data port to the serial port of
the computer.
2. Press the Reset button to power up the wrench.
3. Move the Mode Selection switch to Setup.
4. With the Reset button held in, use the Parameter Adjustment Knob to
select Custom Setup Mode #100. Note: A symbol "TX" appears on the
left hand side of the digital display and the main display shows "---".
5. Rotate the mode Select switch to the tightening mode for which the
option is to be enabled. The display should show "OFF".
6. While holding the Reset button, press the Units key to select the
option. The display will show "ON". Pressing the Joint key deselects it.
7. Rotate the Mode Select switch back to the Setup position. The display
should now show "---" with TX on.