Filter
Top Products
24
Sensor I® Expert User Manual
6. Press the Display key until "Pk" is displayed
on the lower left-hand side of the screen.
7. Press in the Reset button. The snug torque
will be displayed.
8. With the Reset button held in, use the
Parameter Adjustment Knob to adjust the
snug torque to the desired value.
9. Release the Reset button. If the FAULT light
is lit, then press and hold the Reset button
again while holding the wrench steady. Con-
tinue to hold in the Reset until the RUN
light appears and the FAULT light goes off.
Release Reset.
10. Press the Display key until "An" appears in
the lower left-hand corner if angle values
must be displayed during tightening.
11. Commence tightening with moderate speed
steady pulls. Stop as soon as the OK light
comes on and the alarm sounds.
12. When tightening is complete, press the
Display key until "Pk" appears in the lower
left-hand corner. This will display the peak
(or static) torque reading.