Filter
Top Products
10
Sensor I® Expert User Manual
G) This segment will light when the wrench is in calibration mode for torque or
angle.
H) This segment indicated that degrees of angle are being displayed on the
screen.
I) These segments indicate the cycle number for the tightening or the mode
number when in setup mode.
J) These segments indicate the units for torque.
K) These segments indicate the joint type selection for yield control.
L) This segment lights when the torque applied to the wrench is over the
maximum allowable limit.
M) This segment indicated a low battery condition.
N) This segment lights when torque and angle offsets are being calculated.
O) This segment will light when a torque multiplier is programmed for use with a
particular fastening mode.
P) This segment will flash when a particular tightening mode has reached its limit
of 1,000 tightenings. This segment will light continuously when the wrench
has reached its limit of 2,500 total tightenings for all the tightening modes.