Filter
Top Products
40
Sensor I® Expert User Manual
samples have been sent, the display reverts to showing the selected
curve number.
9. Rotate the Mode Select switch back to the Setup position.
10. Holding in the Reset button, adjust the Custom Setup Mode number
below 20.
TORQUE MULTIPLIER FUNCTION
The Sensor I
®
Expert wrench may be used with a torque multiplier to
increase its effective torque output up to a maximum multiplication factor
of ten times (x 10) the capacity of the wrench.
Enabling this custom mode, the wrench can be enabled to select four levels
of multiplication for each primary tightening mode. These are as follows:
Setup of a Torque Multiplier
A multiplier should be used when tightening in that mode if the "MUL"
symbol is indicated. All torque parameters, (i.e., snug, target torque, and
torque QC limits) are now scaled by the multiplier value. Similarly, any angle
parameter, (i.e., target angle or angle QC limit) is divided by the multiplier
value. It is a good idea to check that your parameters for the tightening
mode are as desired by reviewing the QC limits with the Window key. The
snug and target torque can also be checked by selecting the display of peak
torque (Pk) and holding in the Reset button.
1. Multiplication Factor =
x 1 (default value)
2. Multiplication Factor =
x 5
3. Multiplication Factor =
x 4
4. Multiplication Factor =
x .01 (selectable upto x 10.00 maximum