Filter
Top Products
23
Sensor I® Expert User Manual
Angle Control
1. Press and release the Reset button to power
up the wrench.
2. Move the Mode Selection switch to Angle
Control.
3. Attach the angle reference arm (EA-models)
to the wrench, and place the magnet on a
magnetic surface.
4. Press and hold in the Reset button. "An"
will be displayed in the lower left corner and
the angle control point will be shown).
5. With the Reset button held in, use the
Parameter Adjustment Knob to adjust the
angle control point to the desired value.
Release the Reset button.