Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
INSTALLATION
PRO-CUT 60
A-7
OUTPUT CONNECTIONS
To avoid receiving a high frequency shock, keep
the torch and cables in good condition.
__________________
The standard PRO-CUT 60 cutting torch comes
with a 25 ft. (7.6m) cable. A cutting torch with a 50
ft. (15.2m) cable is available. The PRO-CUT 60 is
shipped with the torch and work cables already
connected. Should you have to connect the torch
or work cables, use the following procedure:
See Figure A.4 for the location of torch and work
connections.
Connect cutting torch to machine. See Figure
A.4.
1. Turn OFF Power Line switch.
2. Disconnect input power to the machine.
3. Insert the torch cable into the machine
through the cable boot (8).
a. Insert enough torch cable to make all
connections.
4. Turn and lock strain relief clamp (1) onto bolt
to secure the gas line.
5. Connect the gas line fitting to the brass union
and tighten with a wrench.
6. Connect to pilot lead (5) to terminal marked
“PILOT”.
7. Connect work lead (7) to terminal marked
“WORK”.
8. Connect 4-pin connector (2).
FIGURE A.4. -- Connect Torch Cable To
Machine
Connect work clamp to work clamp cable, which
extends from the front of the machine. See Figure
A.5.
1. Insert the cable through the hole at the end of
the work clamp handle.
2. Pull the work clamp cable through the hole
until it reaches the nut and bolt assembly.
3. Tighten the nut and bolt.
FIGURE A.5. -- Connect Work Clamp
➀
➁
➂
➃
➄
➅
➆
➇
PILOT
WORK
➀ Strain Relief Clamp
➁ 4-Pin Connector
➂ Bulkhead Connector
(Brass Fitting)
➃ Gas Line
➄ Pilot Lead
➅ Bolt
➆ Work Lead
➇ Cable Boot
WARNING