Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
REMOVAL/REPLACEMENT DESCRIPTION
This procedure will assist you in removing or replacing the fan blade and fan motor
in case of a faulty motor or broken fan blade.
MATERIALS NEEDED
Strap to keep Case Front Assembly from falling open
5/16” Nut driver/Screw driver
11/32” Open end wrench
Wire cutter
Pliers
TROUBLESHOOTING & REPAIR
PRO-CUT 60
F-46
FAN BLADE AND FAN MOTOR REMOVAL/REPLACEMENT
Service and repair should be performed only by Lincoln Electric factory trained per-
sonnel. Unauthorized repairs performed on this equipment could result in danger to
the technician or the machine operator and will invalidate your factory warranty. For
your safety and to avoid electrical shock, please observe all safety notes and pre-
cautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform
the tests/repairs safely, contact the Lincoln Electric service department for technical
troubleshooting assistance before you proceed.
Call (216) 383-2531 or (800) 833-9353 (WELD).
If the Case Back Assembly is removed, a restraining strap must be used so the panel
cannot be completely removed until the fan motor leads are disconnected. Failure to
do this could cause damage to the fan motor or fan motor leads.
WARNING
CAUTION