Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
CAPACITOR DISCHARGE PROCEDURE
Failure to follow this capacitor discharge procedure can result in electric shock.
PROCEDURE DESCRIPTION
This procedure must be performed before any test or removal procedure that does
not require the machine to be electrically “hot.”
MATERIALS NEEDED
High resistance, high wattage resistor
( 25-1000 ohms, 25 watts minimum).
Insulated pliers
Insulated gloves
DC Volt/Ohm meter (Multimeter)
TROUBLESHOOTING & REPAIR
PRO-CUT 60
F-13
Service and repair should be performed only by Lincoln Electric factory trained per-
sonnel. Unauthorized repairs performed on this equipment could result in danger to
the technician or the machine operator and will invalidate your factory warranty. For
your safety and to avoid electrical shock, please observe all safety notes and pre-
cautions detailed throughout this manual.
If for any reason you do not understand the test procedures or are unable to perform
the tests/repairs safely, contact the Lincoln Electric service department for technical
troubleshooting assistance before you proceed.
Call (216) 383-2531 or (800) 833-9353 (WELD).
WARNING
WARNING