Filter
Top Products
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
TROUBLESHOOTING & REPAIR
PRO-CUT 60 (12/95)
F-25
MAIN TRANSFORMER TEST
TEST PROCEDURE
1. Connect main input power
supply to machine.
NOTE: When performing Tests A and
B
a. If any one voltage is missing or
below the specification, inspect
the associated plugs and wiring.
If there are no loose plugs or
wiring, then the associated
winding in the main transformer
could be defective. Replace the
main transformer.
b. If all secondary and auxiliary
voltages are missing, then
inspect the Reconnect Panel to
make sure the machine is con-
nected for the proper operating
voltage. If the machine is con-
nected properly, the primary
winding in the main transformer
could be defective. Replace.
Test A: Main Secondary Voltage
Test
1. Locate on the Power Board
leads H1 and H2 to the SCR
module. See Figure F.2.
2. Turn ON/OFF Power Switch to
ON.
3. Test for 190 VAC across leads
H1 and H2.
4. Turn ON/OFF Power Switch to
OFF.
Test B: Auxiliary Winding Tests
1. Perform the four Auxiliary
Winding Tests in Table F.2. Turn
the ON/OFF Power Switch to
ON for each test. Turn the
ON/OFF Power Switch to OFF
between each test. When
testing a lead connected to
a Molex plug, carefully insert the
probe into the cavity of the plug
to make contact with the lead.
See Figures F.1, F.2, and F.10
for component and lead connec-
tion locations. Refer to wiring
diagram.
Auxiliary Winding Test #
1
2
3
4
Test Voltage
From To
Lead #31 on
Control
Relay CR2
Lead #32 on
Control Board at
Plug location 6J10
Lead #C1 on
Control Board at
Plug location 5J5
Lead #32 on
Control Board at
Plug location 6J10
Lead #C2 on
Control Board at
Plug location 1J7
Lead #H6 on
Control Board at
Plug location 3J7
Lead #H3 on
Power Board at
Plug location 3J22
Lead #H4 on
Power Board at
Plug location 1J22
Expected Voltage
115 VAC
24 VAC
24 VAC
12 VAC
Table F.2-Auxiliary Winding Tests