Mitsubishi Electronics CR750-D Welding System User Manual


 
3 Controller
Emergency stop input and output etc.
3-88
(2) CR751 controller
Fig.3-17 Connection of the special-stop-input (CR751)
30cm以内
フェライトコア
2回通し
CNUSR2コネクタ
* Connects with CNUSR2 connector
with soldering.
Refer to Page 86 "Fig. 3-15: Method
of wiring for external emergency stop
connection (CR751 (CNUSR1/2))".
Within 30cm
CNUSR2 connector
Ferrite core
Pass twice
Note) In the customer's system, do not ground the + side of 24V power supply prepared by customer for con
-
nect to the controller. (related with emergency stop and parallel input/output) If it connects with the con-
troller under the condition that the + side is grounded, it will lead to failure of controller.