Mitsubishi Electronics CR750-D Welding System User Manual


 
2-33
Outside dimensions Operating range diagram
2 Robot arm
Fig.2-20 Outside dimensions of RH-3FH5512C
Note
*1) Indicates the space necessary
to replace the battery.
*2) Indicates screw holes (M4
depth 6mm) for fixing user
wiring/piping. Six places on
both-sides of No.2 arm, Two
places on front surface.
*3) The duct is attached to the
clean specification.
*4) The distance to a minimum
bendable radius of the
machine cable for CR750/751
controller.
*5) Indicates the space necessary
to connect the machine cable
for CR750/751 controller.
Note) The drawing shows an example of the CR751 controller connection robot.
Note) Refer to Fig. 2-22 for the mechanical interface section and installation base section dimensions.