Filter
Top Products
7-2 Troubleshooting (Operation)
102
Chapter 7 Troubleshooting
The USB cable came loose during engraving.
If the machine succeeded in receiving all the engraving data,
the engraving is carried out to the end of the operation. If the
machine did not receive all the engraving data, engraving is
carried out for the portion received, and then the cutter rises
and stops at a location away from the workpiece. The mes-
sage [Command Not Recognized] may be displayed at this
time. If this happens, switch off the power and redo the op-
eration from the beginning
☞ P. 40, "Starting and Quitting," p. 104, " Responding to an Error
Message"