Filter
Top Products
4-9 Performing Engraving
77
Chapter 4 Engraving
Adjusting the Cutter Feed Rate During Engraving (Override)
While engraving is in progress, you can pause operation and adjust the feed rate for the cutter. You adjust the feed rate
by specifying a ratio of change relative to the present feed rate. This feature is called “override.”
The feed rate can be adjusted only within the machine’s settable feed-rate range. If a feed rate that falls outside the
settable range is set by an override, the actual feed rate is limited to the maximum or minimum feed rate.
Procedure
➊
While engraving is in progress, press .
Engraving pauses.
☞ P. 54, “Mounting a Workpiece”
➋
Press .
Use
and to set the ratio for feed-rate adjustment.
Press
to confirm.
➌
Press .
The screen shown at left returns.
➍
Use or to select “CONT.” and press .
Engraving resumes.
➢ Settable change ratios
10 to 200% (in steps of 10%)
➢ Settable range for feed rate
X- and Y-axis directions: 0.1 to 60 mm/sec (0.004 to 2.4 in./sec)
Z-axis direction: 0.1 to 30 mm/sec (0.004 to 1.2 in./sec)