76
Chapter 4 Engraving
4-9 Performing Engraving
Performing Engraving
Make sure the following tasks have all been completed, then sent the engraving data from the computer and perform
engraving.
➢ Mounting a Workpiece
☞ P. 54, “Mounting a Workpiece”
➢ Cutter Installation
☞ P. 56 through 71, “Cutter Installation Method 1” through “Cutter Installation Method 4”
➢ Setting the XY Origin Point
☞ P. 75, “Setting the XY Origin Point (Home Position)”
For information about creating engraving data, refer to the documentation for the program you’re using to create the
data.