Filter
Top Products
4-7 Cutter Installation Method 4 (End mill)
73
Chapter 4 Engraving
3.
Make the settings for spindle speed and Z-axis control.
➊
Press several times to display the screen shown at left.
Use
and to select [OTHERS].
Press
.
➋
Use to select "ON."
Press
to confirm.
➌
Press .
Use
to select "OFF."
Press
to confirm.
The message shown at left is displayed for three seconds, and then the original
screen returns.
➍
Press several times to return to the main screen.
4.
Set the Z-axis origin point.
➊
Use , , and to move the end mill to a location above the workpiece.
Next, perform a small amount of cutting into the workpiece. Move to a location where cutting will not cause any
problems.
☞ P. 44, "Manual Movement"
➋
Close the front cover, then press and hold for at least one second.
The spindle rotates.
☞ P. 47, "Starting and Stopping Spindle Rotation"
➌
Press to lower the end mill to a
location where the workpiece is cut by
a slight amount.
➍
Press .
The spindle stops.
Workpiece
End mill