Filter
Top Products
49
Chapter 3 Basic Operation
3-6 Pausing and Stopping Cutting
Pausing and Resuming Cutting
This pauses cutting through operation using the handy panel. This enables you to move the cutter to the VIEW position
and check the status of the workpiece, then resume cutting at the location where you paused operation.
Procedure
➊
While cutting is in progress, press .
Movement of the cutter pauses. Rotation of the spindle does not
stop at this time.
The display screen shown at left appears.
➋
➀
Use to select “VIEW.”
➁
Press to confirm.
Rotation of the spindle stops, and the cutter moves to the VIEW
position.
☞ P. 45, “Moving to a Specific Position Automatically”
➌
➀
Use or to select “CONT.”
➁
Press to confirm.
The cutter returns to the location where paused, and cutting re-
sumes.
Selecting “VIEW” or “CONT.” while the front cover is open makes
the message shown in the figure below appear. After three seconds
the message disappears and the screen returns to the original menu.
Close the front cover, then redo the selection of the operation item.
➀➁
➀➁