Filter
Top Products
3-4 Moving the Cutter
45
Chapter 3 Basic Operation
Moving to a Specific Position Automatically
Procedure
➊
Close the front cover.
➋
At the main screen, press twice.
➌
Press , , , or to select the move-
ment destination.
➢ HOME
This is the location where the X- and Y-axis coordinates are both
“0” (the XY origin point). When movement by this operation is per-
formed, to avoid contact with the workpiece, the machine first rises
to the highest point along the Z axis, and then performs movement.
☞ P. 75, “Setting the XY Origin Point (Home Position)”
➢ VIEW
This is the inner-left location on the workpiece table. You use it in
situations such as when mounting or removing a workpiece, or
when checking the state of the workpiece.
➢ Z0
This is the location where the Z-axis coordinate is “0.”
☞ P. 62, “Cutter Installation Method 2,” p. 71, “Cutter Installation Method 4,” and p.
92,“Origin-setting Menu”
➢ Z1
This is the location of the cutting-in depth when cutting the
workpiece.
☞ P. 92, “Origin-setting Menu”
➢ Z2
This is the height location along the Z axis when performing no-
load feed of the cutter during cutting.
☞ P. 92, “Origin-setting Menu”