Filter
Top Products
4-5 Cutter Installation Method 2 (No Nose Unit)
63
Chapter 4 Engraving
➋
Install the solid collet.
➀
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Use an appropriate solid collet for the
cutter’s diameter.
➁
Fully tighten the solid collet.
Using two wrenches, tighten the solid
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
2.
Set the lock lever.
Set the lock lever at the position.
The spindle head is secured in place.
☞ P. 82, "The Position of the Lock Lever"
Lock lever
Lift up.
Wrench
Spindle unit
Solid collet
Wrench
➀
➁
Wrench