4-5 Cutter Installation Method 2 (No Nose Unit)
64
Chapter 4 Engraving
3.
Make the settings for spindle speed and Z-axis control.
➊
Press several times to display the screen shown at left.
Use
and to select [OTHERS].
Press
.
➋
Use to select “ON.”
Press
to confirm.
➌
Press .
Use
to select “OFF.”
Press
to confirm.
The message shown at left is displayed for three seconds, and then the original
screen returns.
➍
Press several times to return to the main screen.
4.
Install the cutter and set the Z-axis origin point.
➊
Use , , , and to
move the spindle head to the area above
the workpiece, then press
to
lower the spindle head.
Stop at a position where the tip of the solid
collet is approximately 10 millimeters from
the surface of the workpiece.
☞ P. 44, "Manual Movement"
➋
Insert the cutter into the cutter holder
and bring the tip of the cutter into con-
tact with the surface of the workpiece.
Placing a thin sheet of paper on the workpiece
can prevent damage to the workpiece when
the cutter touches it. However, take the thick-
ness of the paper into account when you set
the Z-axis origin.
Solid collet
Workpiece
Cutter
Cutter holder
Workpiece
