Filter
Top Products
5-5 Description of Menu Items
92
Chapter 5 Feature reference
Origin-setting Menu
☞ P. 86, "Origin-setting Menu"
XY Origin-setting Menu
This makes the setting for the X- and Y-axis origin point. On this machine, this
location is called the “home position.”
☞ P. 75, "Setting the XY Origin Point (Home Position)"
Z Origin-setting Menu
Before making these settings, make sure of the following points.
➢ [AUTO Z CONTROL] must be set to “OFF.”
If it is set to “ON,” pressing
displays the message shown in the figure below. After three seconds, the
message disappears and the original menu returns.
☞ P. 82, "The Position of the Lock Lever," p. 71, "Cutter Installation Method 4"
Z0: This is the Z-axis origin point during cutting. Set this to match the workpiece
and the cutting data. The lock lever is normally set at position
.
☞ P. 62, "Cutter Installation Method 2," p. 71, "Cutter Installation Method 4"
Z1: This sets the cutting-in depth during cutting as the distance from the Z0
position. This means that a change in the Z0 position makes the Z1 position
change as well. Because this cannot be set at a location higher than the Z0
position, the value of the setting must be negative. If the spindle head is at a
higher location than Z0, the screen displays “
” for the Z-axis coordinate.
The lock lever is normally set at position
. When you’ve made the setting on
the computer, the computer’s setting takes precedence. Making this setting is
not required.
Z2: This sets the height along the Z axis when performing no-load feed of the
cutter during cutting as the distance from the Z0 position. This means that a
change in the Z0 position makes the Z2 position change as well. Because this
cannot be set at a location lower than the Z0 position, the value of the setting
must be positive. If the spindle head is at a lower location than Z0, the screen
displays “
” for the Z-axis coordinate. The lock lever is normally set at
position
.When you’ve made the setting on the computer, the computer’s
setting takes precedence, and so making this setting is not necessary.