Filter
Top Products
103
Chapter 7 Troubleshooting
7-3 Responding to a Message
These are the most common messages that appear on the
machine’s display to prompt correct operation. They do
not indicate any error. Follow the prompts and take action
accordingly.
[Please close the cover]
Close the front cover.
To ensure safety, the machine does not operate when the
front cover is open. However, operations using the move-
ment buttons on the handy panel are possible while the cover
is open.
[Stop performing COVER OPEN]
Close the front cover.
The front cover was opened while the cutter was moving to
a reference point, and so operation of the cutter stopped to
ensure safety.
[Pause On COVER OPEN]
Close the front cover.
This is displayed in the following cases.
➢ Engraving data was sent while the front cover was open.
➢ "VIEW" was selected at the Pause menu, and the cover
was opened during movement to the VIEW position.
Closing the front cover returns the display to the Pause menu.
☞ P. 49 "Pausing and Resuming Cutting"
[Canceling data...]
This is displayed if engraving data is sent during initializa-
tion. After processing to delete the data finishes, the mes-
sage disappears. When the amount of data is large, it may
take some time for the message to disappear.
[Cannot repeat too big data]
This is displayed when an attempt was made using the Copy
menu to perform engraving again, but the engraving data
just received was too large for the machine’s memory capac-
ity. After three seconds this message disappears and the screen
returns to the original menu.
[Cannot repeat buffer empty]
This is displayed when an attempt is made using the Copy
menu to perform engraving again while no engraving data is
saved in the machine. After three seconds this message dis-
appears and the screen returns to the original menu.
☞ P. 78 "Executing Repeated Cutting"
[Turn the AUTO Z CONTROL off]
This was displayed because an attempt was made to set the
Z0, Z1, or Z2 position even though automatic Z control is
on.
After three seconds this message disappears and the screen
returns to the original menu.
☞ P. 92 "Origin-setting Menu"