Filter
Top Products
4-6 Cutter Installation Method 3 (Diamond Scraper)
68
Chapter 4 Engraving
➋
Install the solid collet.
➀
Loosely tighten the solid collet.
Insert the solid collet into the spindle unit
from below, then, while holding the
spindle unit immobile with a wrench,
tighten loosely.
Diameter-4.36 millimeter diamond scrap-
ers cannot be used with the included solid
collet. Provide a dedicated diamond-
scraper collet separately.
➁
Fully tighten the solid collet.
Using two wrenches, tighten the solid
collet fully. The appropriate tightening
torque is 3.2 N-m (32kgf-cm) .
2.
Set the lock lever.
Set the lock lever at the or posi-
tion.
For detailed information about the setting
position for the lock lever, refer to the page
indicated below.
☞ P. 82, “The Position of the Lock Lever”
Lock lever
Press down to lower
slightly.
Wrench
Spindle unit
Solid collet
Wrench
➀
➁
Wrench