Filter
Top Products
5-5 Description of Menu Items
90
Chapter 5 Feature reference
Others Menu (Submenu)
☞ P. 85, "Submenus"
This determines whether the spindle is rotated during cutting. When this is set
to “OFF,” scribing (cutting without rotation of the spindle) is performed.
➢ Default setting: ON
Set this to “ON” in cases such as when you’re using the nose unit. Setting this to
“ON” enables automatic detection of the Z origin point as the position where
the tip of the nose unit or cutter touches the surface of the workpiece.
When the lock lever is positioned at
, set this to “OFF.” Leaving this set at
“ON” may cause an error and make operation impossible to continue.
➢ Default setting: OFF
This is displayed when [AUTO Z CONTROL] is set to “ON.” This sets the cut-
out amount when [AUTO Z CONTROL] is set to “ON.”
➢ Default setting: 500 (5 mm)
This selects a resolution that matches the program used to create the engraving
data. When you’re performing output from the included Windows-based driver,
set this to “0.1mm.”
➢ Default setting: 0.01 mm
The cutter stops moving when a command is received that specifies movement
outside the range of operation for the X and Y axes. Movement starts again
when a command to return from that location to the range of operation is re-
ceived. You can select either of the following as the response taken when this
occurs.
➢ [CONTINUE]:
When a command for return to the range of operation is received, operation
resumes immediately.
➢ [PAUSE]:
When a command for return to the range of operation is received, operation
is paused and the Pause menu appears on the display screen. Use the opera-
tion panel to select the operation to perform thereafter.
☞ P. 49, “Pausing and Resuming Cutting”
➢Default setting:
CONTINUE