Filter
Top Products
3-4 Moving the Cutter
44
Chapter 3 Basic Operation
Manual Movement
When the screen on the handy panel displays any one of the messages shown in the figure below, you can move the
cutter manually using the movement buttons.
☞ P. 84, "Menu List"
➢ Each single press of , , , , or performs movement by 0.01 millimeter.
➢ Holding down , , , , or performs slow continuous movement.
➢ Holding down while pressing and holding , , , , or performs rapid
continuous movement.
Important!
This operation is not possible in the following cases.
➢ When engraving is in progress
➢ When operation is paused
-
X
-
Y
+
Z
-
Z
+
X
+
Y
+
Y
-
Y
+
X
-
X
+
Z
-
Z
Movement along only the X
and Y axes
Movement along all axes
(X, Y, and Z)
Movement along only the Z
axis
(“XXX” is “DOWN,” “SUR-
FACE,” or “UP.”)
Handy panel
Movement buttons