Filter
Top Products
5-1 Attaching the Vacuum Adapter for Chip Cleaning
81
Chapter 5 Feature reference
Move the spindle head to the front left of the workpiece table, then attach the vacuum adapter for chip cleaning as
shown in the figure. Using the vacuum adapter for chip cleaning enables the vacuum cleaner to take up cutting waste
during cutting, which can help keep scattering of cutting waste to a minimum.
☞ P. 44, "Manual Movement"
Position so that the retaining screw
for the nose unit is between the tabs
of the clamp.
Retaining
screw
Tab
Tab
Bar
Hose
Pass through above the bar.
Vacuum adapter
clamp
Provide a gap large enough
to ensure no striking.
Hose
Clip
Clip
Hose
Front
To p
Hose
Nose unit
32mm
(1.3 in.)
Secure using the clip. *
Note: Wind the clip around the hose to hold the hose securely so that it won’t easily come loose.
Rear
Secure using the clip. *